Setting up a Private/Internal Network.

To setup a private network, ensure your account is provisioned for Private Networking. This is a free service, but does require being enabled.

On each VM that you wish to have connectivity to your private network(s), you will need to complete the following steps.

  1. Assign a new Network Interface under [Your Virtual Server] > Network > Interfaces, and select your private network.
  2. Assign an IP address from your private address pool to the system under [Your Virtual Server] > Network > IPs
  3. Modify or Enable/Disable the firewall rules for the newly created Interface under [Your Virtual Server] > Network > Firewall

Remember to also verify that your Virtual Server's Guest OS firewall rules are configured to also allow this traffic.


Was this article helpful?

mood_bad Dislike 0
mood Like 0
visibility Views: 711